![]() ![]() Multiple z level passes will be automatically calculated where the tool needs to cut deeper than its Pass Depth specified in the Tool Database. When No Flat Depth specified the toolpath will be calculated to carve or engrave to full depth as shown below. If the V-Carving / engraving is going to be machined into the bottom of a pocket or stepped region, the depth of the pocket / step must be entered.įor example, to carve or engrave into the bottom of a 0.5 inch deep pocket, the Start Depth = 0.5 inchesĬhecking ✓ this option limits the depth that the tool(s) will machine to, and is used for Flat Bottomed Carving and Engraving. When cutting directly into the surface of a job the Start Depth will usually be 0.0. Start Depth (D) specifies the depth at which the V-Carving toolpath is calculated, allowing V-Carving / Engraving to be machined inside a pocket region. This icon opens the V-Carving Toolpath form which is used to specify the type of carving required, tooling details, cutting parameters and name for the toolpath. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |